FAQs & Troubleshooting

Close

JA20

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 12/12/2018 ID: faqh00000017_002

How do I sew hook-and-loop fasteners(hook-and-loop tapes)?

 

 

  • Use only the ungummed hook-and-loop fastener which is for sewing. If the glue is attached to the needle or the bobbin hook race, it may cause malfunction.
  • If the hook-and-loop is sewn with the thin needle (65/9-75/11), the needle may bend or break.
  • Before start sewing, baste together the fabric and the hook-and-loop fastener.

 

 

 

Make sure that the needle passes through the hookand-loop fastener by turning the handwheel and lower the needle into the hook-and-loop fastener before sewing. And then, sew the edge of the hookand-loop fastener at a slow speed.
If the needle does not pass through the hook-andloop fastener, replace the needle with the needle for thick fabrics.

hook-and-loop fastener 1 Edge of the hook-and-loop fastener
 

Related FAQs

Related Models

AS1430S, FS155, FS70, GS2700, GS3700, Innov-is 1200, Innov-is 1500D/1500, Innov-is 15P, Innov-is 400, Innov-is 4000D/4000, Innov-is 55P, Innov-is 980K, Innov-is I / Innov-is 6000D, Innov-is Ie, Innov-is V7, JA1400, JA1450NT, JA20, JK17B, JS1410, JV1400, LS-2125/2160, LX27NT, NX-400Q/400, PQ-1500/1500S, PS-53/55/57, XT37

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.