1034D
 |
FAQs & Troubleshooting |
1034D
Date: 24/12/2015 ID: faqh00000495_000
Before threading
-
Turn off the main power switch for safety.
-
Raise the presser foot using presser foot lever.
When threading the needle, always be sure to lift the presser foot lever, and also take care to thread in the proper order.
-
Set the needle bar in its highest position by turning the handwheel toward you.
Turn the handwheel to find the easiest position for threading, and then thread the upperlooper thread, lowerlooper thread, right needle thread and then the left needle thread.
The proper threading order for this serger is upperlooper, lowerlooper, right needle, and then the left needle.
Slide to the right
Thread tension discs
Correct
Wrong
1034D, 1334D
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.