1034D
 |
FAQs & Troubleshooting |
1034D
Date: 24/12/2015 ID: faqh00000492_000
Preparation before threading
Raise the telescoping thread tree to its highest position.
Make sure that the thread holders are in alignment above the spool pins as illustrated below.
(1) Thread holder on thread tree
(2) Spool pin
(3) On Two-needle models
(4) Correct position
When threading, always thread in this order: upperlooper, lowerlooper, right needle and then the left needle.
1034D, 1334D
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.