SDX1200
FAQs & Troubleshooting |
SDX1200
Date: 03/10/2018 ID: faqh00000691_002
The mat is fed in at an angle.
Possible Causes (or Results)
Case1 : | The mat was inserted into the feed slot at an angle. |
Case2 : | The corners of the mat are deformed (bent). |
Case3 : | The rear tray is not pulled out. |
Case4 : | The feed roller is not positioned correctly. |
Case5 : | The shaft is released. |
Solutions
----- Case1 -----
Press the (Feed) button to feed out the mat.
Re-insert the mat straight in.
----- Case2 -----
Replace the mat with a new one.
----- Case3 -----
Pull out the rear tray.
----- Case4 -----
Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller
----- Case5 -----
Lock the shaft.
SDX1200
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.