FAQs & Troubleshooting

Close

HL-L9430CDN

FAQs & Troubleshooting

FAQs & Troubleshooting

HL-L9430CDN

Not your product?

Date: 10/01/2023 ID: faq00000315_506

Replace the Waste Toner Box

Before starting the replacement procedure, see Related Information: Replace Supplies.

  1. Make sure the machine is turned on.
  2. Press the front cover release button and open the front cover.
    image
  3. Hold the drum unit's green labeled handle. Pull the drum unit out of the machine until it stops.
    image
    CAUTION
    We recommend placing the toner cartridges and the drum unit assembly on a clean, flat surface with disposable paper underneath it in case you accidentally spill or scatter toner.
  4. Holding the green labeled handles of the drum unit, lift the front of the drum unit and remove it from the machine.
    image
    IMPORTANT

    Hold the handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.

    image
  5. Push down the belt unit release lever to lift the belt unit up.
    image
  6. Hold the handle of the belt unit with both hands and lift the belt unit up, then pull it out.
    image
  7. Remove the two pieces of orange packing material and discard them.
    image
    image
    This step is only necessary when you are replacing the waste toner box for the first time, and is not required for the replacement waste toner box. The orange packing pieces are installed at the factory to protect your machine during shipment.
  8. Hold the green handle of the waste toner box and remove the waste toner box from the machine.
    image
    image
    DO NOT reuse the waste toner box.
  9. Unpack the new waste toner box and install the new waste toner box in the machine using the green handle. Make sure the waste toner box is level and fits firmly into place.
    image
  10. Slide the belt unit back into the machine. Make sure the belt unit is level and fits firmly into place, and the belt unit release lever is secured.
    image
  11. Gently slide the drum unit into the machine until it stops.
    image
  12. Using the green labeled handle, push the drum unit back into the machine until it locks in place.
    image
  13. Close the machine's front cover.

Related Models

HL-L9430CDN

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit