MFC-T910DW
FAQs & Troubleshooting |
MFC-T910DW
Date: 26/04/2018 ID: faq00000105_511
Reset the Network Settings to Factory Default
You can use your machine's control panel to reset the print server to its default factory settings. This resets all information, such as the password and IP address.
- IMPORTANT
- (MFC-T810W/MFC-T910DW)
When you reset the machine, your faxes that are stored in the machine's memory may be deleted. Before you reset the machine, you can transfer your faxes to your computer or another fax machine so you will not lose any important messages.
- This feature restores all wired (supported models only) and wireless network settings to the factory settings.
- You can also reset the print server to its factory default settings using BRAdmin Light or BRAdmin Professional.
DCP-T510W/DCP-T710W/MFC-T810W
- Press Menu.
- Press or to select the following:
- Select [Initial Setup]. Press OK.
- Select [Reset]. Press OK.
- Select [Network Reset]. Press OK.
- Press for [Reset] to confirm.
- Press for [Yes] to reboot the machine.The machine restarts.
MFC-T910DW
- Press Settings.
- Press or to select the following:
- Select [Network]. Press OK.
- Select [Network Reset]. Press OK.
- Press for two seconds to confirm.The machine restarts.
DCP-T510W, DCP-T710W, MFC-T910DW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.