DCP-T420W
 |
FAQs & Troubleshooting |
DCP-T420W
Date: 01/03/2024 ID: faq00100704_500
Configure Network Settings Using the Control Panel
To configure the machine for your network, use the control panel buttons.
Network Settings
| Function | Button 1 | Button 2 | Instructions |
|---|
| Enable the One Push Method of Wi-Fi Protected Setup™ (WPS). | WiFi Button/LED | - | Press the button three times. |
| Enable the PIN Method of Wi-Fi Protected Setup™ (WPS). | WiFi Button/LED | - | Press the button five times. |
| Enter Wi-Fi Mode. | WiFi Button/LED |  | Press the buttons simultaneously. |
| Set Wireless Direct to On. Print the Wireless Direct Information Sheet. | WiFi Button/LED | Copy Shortcut | Press the buttons simultaneously. |
| Print the Network Configuration Report Sheet. | WiFi Button/LED | Mono Start | Press the buttons simultaneously. |
| Restart Wi-Fi and Wireless Direct. Use this function to solve wireless network problems. | WiFi Button/LED | Colour Start | Press the buttons simultaneously. |
Wi-Fi Mode
| Function | Button | Instructions |
|---|
| Print the WLAN Report. | WiFi Button/LED | Press the button once. |
| Enable or disable Wireless Direct. | Copy Shortcut | Press the button once. |
| Enable or disable Wi-Fi. | Mono Start | Press the button once. |
| Reset the Network settings. | Colour Start | Press and hold the button for two seconds. |
DCP-T420W, DCP-T426W
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.