If the NC-2200w cannot be found using the 'Wireless Setup Wizard' or the 'BRAdmin Professional' software, check the following:

1. Check the connection between the NC-2200w and the Printer/MFC/DCP:

    

   Press the 'Test' button of the NC-2200w for 1-2 seconds to print the configuration page of the NC-2200w. If it is printed, the USB cable connection between the NC-2200w and the Printer/MFC/DCP is OK.

2. Check the NC-2200w:

    

   Check the LEDs. When the LEDs are lit as follows, the NC-2200w is working OK.

   • 'Link' LED is on (green).
   • 'Infra' LED is on when in the NC-2200w is in Infrastructure mode. (Off when in Ad-hoc mode.)
     

   If the LEDs are not lit correctly, remove the AC adopter power cable from the NC-2200w and try again.

3. Check the computer is in Ad-hoc mode.

   Make sure your computer has been configured for Ad-hoc mode.

   The "Wireless Setup Wizard" can only configure the NC-2200 when in Ad-hoc mode.

   To see the quick setup guide, click here (PDF file)

4. Other Possibilities:

   
   Make sure that you are using the latest firmware version and software for your Brother wireless product, Access Point and wireless LAN card.