TJ-4121TN
FAQs & Troubleshooting |
TJ-4121TN
Date: 12/10/2021 ID: faqp00100470_004
How to reset the printer settings by directly operating the printer
Printer initialization clears the printer's DRAM and restores its factory settings.
- Turn off the printer.
- Press and hold the right Selection button, and then turn on the printer.
- Release the button when Factory Default appears on the Touchscreen.
After the initialization, the following factory settings will be restored:
Parameter | Default setting |
---|---|
Speed | 127 mm/sec (5 ips) (203 DPI) 76 mm/sec (3 ips) (300 DPI) |
Density | 8 |
Label Width | 101.5 mm (4") |
Label Height | 101.5 mm (4") |
Sensor Type | Gap sensor: TJ-4020TN, TJ-4021TN, TJ-4120TN, TJ-4121TN Black sensor: TJ-4021TNR, TJ-4121TNR |
Gap Setting | 3 mm (0.12") |
Print Direction | 0 |
Reference Point | 0,0 (upper left corner) |
Offset | 0 |
Tear Mode | On |
Peeler Mode | Off |
Cutter Mode | Off |
Rewinder Mode | Off |
Code Page | 850 |
Country Code | 001 |
Clear Flash Memory | No |
TJ-4021TN, TJ-4121TN
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.