FAQs & Troubleshooting

Close

Innov-is NQ575PRW / Innov-is NQ575

FAQs & Troubleshooting

FAQs & Troubleshooting

Innov-is NQ575PRW / Innov-is NQ575

Not your product?

Date: 10/07/2016 ID: faqh00000633_012

How do I change the needle ?

Sewing with a bent needle is extremely dangerous since the needle may break while the machine is being operated. Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even.

image (1) Flat side

(2) Needle type marking

If the distance between the needle and the flat surface is not even, the needle is bent. Do not use a bent needle.

image

(1) Flat surface

Replace the needle in cases such as the four described below:

  1. If an unusual sound is produced when the needle enters the fabric while sewing trial stitches at low speed. (The tip of the needle may be broken.)
  2. If stitches are skipped. (The needle may be bent.)
  3. After completing one project, such as a piece of clothing.
  4. After using three full bobbins of thread.
  1. Press image (Needle position button) once or twice to raise the needle.

  2. Turn off the machine.

    Before replacing the needle, be sure to turn off the machine, otherwise injuries may occur if the “Start/Stop” button or any other button is pressed and the machine starts operating.

     

  3. Place fabric or paper under the presser foot to cover the hole in the needle plate.

    Before replacing the needle, cover the hole in the needle plate with fabric or paper to prevent the needle from falling into the machine.

     

  4. Lower the presser foot.
    image (1) Presser foot lever

     

  5. Hold the needle with your left hand, and then use a screwdriver to turn the needle clamp screw toward you (counterclockwise) to remove the needle.
    The needle clamp screw can also be loosened or tightened with the disc-shaped screwdriver.
    image (1) Screwdriver

    (2) Needle clamp screw

    Do not apply a strong force when loosening or tightening the needle clamp screw, otherwise certain parts of the machine may be damaged.

    image

     

  6. With the flat side of the needle toward the rear of the machine, insert the needle until it touches the needle stopper.
    image (1) Needle stopper

     

  7. While holding the needle with your left hand, use the screwdriver to tighten the needle clamp screw.
    Turn the screw toward the back of the machine (clockwise).
     

    image

    Be sure to insert the needle until it touches the needle stopper and securely tighten the needle clamp screw with the screwdriver, otherwise the needle may break or damage may result.

Related Models

Innov-is NQ550PRW / Innov-is NQ550, Innov-is NQ575PRW / Innov-is NQ575, Innov-is PS500

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.