EV1-LE
 |
FAQs & Troubleshooting |
EV1-LE
Date: 09/26/2018 ID: faqh00101083_000
Stitch pattern does not turn out
-
Wrong presser foot was used.
Attach the correct presser foot.
-
Did not use a stabilizer material on thin fabrics or stretch fabrics.
Attach a stabilizer material.
Refer to Tips for sewing thin fabrics , For better results when sewing stretch fabrics.
-
Thread tension is set incorrectly.
Adjust the thread tension.
Refer to How to adjust the thread tension , Incorrect thread tension.
-
Fabric was pulled, pushed or fed at an angle while it was being sewn.
Sew while guiding the fabric with your hands so that the fabric is fed in a straight line.
-
The thread is tangled, for example, in the bobbin case.
Remove the tangle thread. If the thread is tangled in the bobbin case, clean the race.
Refer to How do I clean the race?
Related FAQs
EV1, EV1-LE, Innov-is XJ1, Innov-is XJ2, Innov-is XP1, Innov-is XP2, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.
Please do not enter contact information or any other personal information here.
(We will not respond to any Feedback you send us.)