CM650WX
 |
FAQs & Troubleshooting |
CM650WX
Date: 11/28/2013 ID: faqh00000691_000
The mat is fed in at an angle.
Possible Causes (or Results)
Case1 : The mat was inserted into the feed slot at an angle.
Case2 : The corners of the mat are deformed (bent).
Solutions
----- Case1 -----
Press the “Feed” button 
to feed out the mat, and then re-insert it straight in.
----- Case2 -----
Replace the mat with a new one.
Related FAQs
CM100DM, CM250, CM300, CM350, CM350e, CM350H, CM350R, CM550DX/ CM550, CM650W, CM650WX
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.
Please do not enter contact information or any other personal information here.
(We will not respond to any Feedback you send us.)