CM300
 |
FAQs & Troubleshooting |
CM300
Date: 07/31/2015 ID: faqh00000700_000
The material being cut catches on the tip of the cutting blade.
Possible Causes (or Results)
Case1 : Dust or lint has accumulated in the holder.
Case2 : The blade is worn.
Case3 : The material being cut is incompatible with this machine.
Solutions
----- Case1 -----
Clean the holder.
>> For details, see “Cleaning the holder”.
----- Case2 -----
Replace the blade with a new one.
>> For details, see “Replacing the blade”.
----- Case3 -----
Replace the material with one compatible with this machine.
>> For details, see “Preparation of craft paper / fabric”.
Related FAQs
CM100DM, CM250, CM300, CM550DX/ CM550
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.
Please do not enter contact information or any other personal information here.
(We will not respond to any Feedback you send us.)