FAQs & Troubleshooting

Close

BM-3600

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 07/03/2015 ID: faqh00000438_009

How do I wind the bobbin?

image (1) Pre-tension disk
(2) Bobbin winder shaft
  • Only use bobbins (part code: SA156, SFB: XA5539-151) that have been designed for this sewing machine. Using other bobbins may cause damage to the machine.
  • We designed the bobbin that comes with this machine. If you use bobbins from other models, the machine will not work properly. Only use the bobbin that comes with this machine or bobbins of the same type (part code: SA156, SFB: XA5539-151).

Use the bobbin that comes with this machine or bobbins of the same type

(1) This model      (2) Other models

 

  1. Turn on the sewing machine.

     

  2. Pull up the spool pin as far as possible, and then put a spool of thread on this pin.

     

    image 

    If the spool of thread is not in the right place, the thread may tangle on the spool pin.

     

     

  3. Pass the thread around the pre-tension disk.

    image

    Make sure that the thread passes under the pre- tension disk.

     

  4. Pass the end of the thread through the hole on the bobbin from the inside of the bobbin.

     

    image

     

  5. Put the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right.

     

    image

  6. Turn the bobbin clockwise, by hand, until the spring on the shaft slides into the groove of the bobbin.
    image (1) Spring on the shaft
    (2) Groove of the bobbin

    Make sure that the thread between the spool and the bobbin is pulled tight.

     

  7. While holding the end of the thread, gently press the foot controller to wind the thread around the bobbin a few times.
    Then stop the machine.
    image

     

  8. Trim the excess thread above the bobbin.

    image

     

     

  9. Press the foot controller to start.

    image

     

  10. When the bobbin seems full and begins spinning slowly, take your foot off the foot controller.

     

  11. Cut the thread, slide the bobbin winder shaft to the left (A) and remove the bobbin (B).

     

image

Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle.

Wind the bobbin properly

(1) Wound evenly   (2) Wound poorly

 

  • When the sewing machine is started or the handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction.
  • The needle bar does not move when you slide the bobbin winding shaft to the right.

 

Related FAQs

Related Models

BM-2700, BM-3600, LS-590, XL-2600/2600i/2610, XL-3500/ t/ i/3510/3520, XL-3750

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.