TD-4650TNWB
FAQs & Troubleshooting |
TD-4650TNWB
Date: 12/01/2021 ID: faqp00001434_012
How do I clean / maintain my printer?
> Clean the Sensors
> Clean the Tear Bar/ Peel Bar
> Clean the Exterior/ Interior
- Turn off the printer.
-
Press the tabs on both sides of the printer, and then lift the Roll Compartment Cover.
-
Use compressed air or vacuum to clean the Gap Sensor (1) and Black Mark Sensor (2).
1. Gap Sensor
2. Black Mark SensorWe recommend cleaning the sensors once per month.
-
Press the tabs on both sides of the printer, and then lift the Roll Compartment Cover.
-
Wipe the Tear Bar (1) and the Peel Bar (2) with a lint-free cloth dipped in isopropyl alcohol or ethanol, as needed.
1. Tear Bar
2. Peel Bar
Exterior: Wipe with a lint-free cloth dipped in water, as needed.
Interior: Use a brush or vacuum, as needed.
Related FAQs
TD-4650TNWB, TD-4750TNWB
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.