Innov-is XE1
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_inovxe1eus.jpg)
Innov-is XE1
Date: 07/29/2019 ID: faqh00101110_002
Using the embroidery needle plate cover
Under some conditions, based on the type of fabric, stabilizer, or thread being used, there may be some looping in the upper thread. In this case, attach the included embroidery needle plate cover to the needle plate. Attach the cover by inserting the two projections on the underside of the cover into the notches on the needle plate as shown below.
![]() |
(1) Groove (2) Projection (3) Notch |
To remove the embroidery needle plate cover, place your fingernail in the groove and lift the plate out.
Push the embroidery needle plate cover as far as possible to attach it. If the embroidery needle plate cover is not securely attached, it may cause the needle to break.
Innov-is BP3600, Innov-is BP3700, Innov-is XE1, Innov-is XE2
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.