FAQs & Troubleshooting

Close

DCP-395CN

FAQs & Troubleshooting

FAQs & Troubleshooting

DCP-395CN

Not your product?

Date: 04/25/2012 ID: faq00002925_000

Load photo paper into my machine.

Use the photo paper tray (photo bypass tray), which is located on top of the output paper tray cover, to print on Photo (10 x 15 cm (4 x 6 in.)) and Photo L (89 x 127 mm (3.5 x 5 in.)) size paper.

When you use the photo paper tray (photo bypass tray), you do not have to remove the paper from the tray beneath it.

To load photo paper in your Brother machine's photo paper tray (photo bypass tray), follow these steps:

NOTE: Illustrations shown below are from a representative product and may differ from your Brother machine.


  1. Squeeze the photo paper tray (photo bypass tray) release (1) button with your right index finger and thumb and push the photo paper tray (photo bypass tray) forward until it clicks into the photo printing position (2).
    Move photo printing position

  2. Press and slide the paper side guides (1) and paper length guide (2) to fit the paper you are loading.
    Slide paper guide to fit paper

  3. Put the photo paper into the photo paper tray (photo bypass tray) and gently adjust the paper side guides to fit the paper.

    • Load photo paper with the shiny side facing down.

    • Make sure the paper side guides touch the sides of the paper.

    • Verify the paper is flat in the tray. Overfilling the paper tray may cause paper jams.

    • Always make sure the paper is not curled or wrinkled.
Do not push the paper too far into the tray. If you do, it may lift at the back of the tray and cause feed problems.
  1. When you have finished printing photos, return the photo paper tray (photo bypass tray) to the normal printing position. If you do not, the machine will produce a "No Paper Fed" error when you use A4, Letter or Legal size paper.

    Squeeze the photo paper tray (photo bypass tray) release button (1) with your right index finger and thumb and pull the photo paper tray (photo bypass tray) back until it clicks into the normal printing position (2).
    Move normal printing position
If you do not return the photo paper tray (photo bypass tray) to the normal printing position after printing photos, you will get a "No Paper Fed" error when you use cut-sheet paper.
Normal printing position      Photo printing position
Normal Printing Position      Photo Printing Position


Removing small printouts from the machine

When your machine ejects small paper on to the output paper tray cover, you may not be able to reach it. Make sure printing has finished, and then pull the tray completely out of the machine.


Remove small printouts

Related FAQs

Related Models

DCP-395CN, MFC-495CW, MFC-795CW, MFC-J615W, MFC-J630W

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.