FAQs & Troubleshooting

Close

PT-P300BT

FAQs & Troubleshooting

FAQs & Troubleshooting

PT-P300BT

Not your product?

Date: 06/04/2019 ID: faqp00100008_003

The label does not cut well.

If the label does not cut well or tape is jammed in the cutter, the cutter blade may have become blunt after repetitive use. To solve this problem, follow the steps below.


First, rotate and reset the Cutter Board as shown in the illustration (1).

Rotate Cutter Board


If you still have difficulties, replace with the new Cutter Unit (Accessory: TC-4) by obtaining from an authorized Brother reseller.
To replace the Cutter Unit, follow the steps below:


  1. Pull out the two sections of the Cutter Unit (green) in the direction of the arrows shown in the illustration (2).
  2. Install the new Cutter Unit by pressing the two new pieces down until they lock into place.

 

Replace Cutter Unit

 

Do not touch the cutter blade with your bare hands.

Related Models

PT-P300BT

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.