FAQs & Troubleshooting

Close

Model discontinued. This page is no longer updated.

NC-2200w

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 09/24/2007 ID: faq00000457_000

I cannot configure the NC-2200w. What can I do?

If the NC-2200w cannot be found using the 'Wireless Setup Wizard' or the 'BRAdmin Professional' software, check the following:

 


  1. Check the connection between the NC-2200w and the Printer/MFC/DCP:

     

    Press the 'Test' button of the NC-2200w for 1-2 seconds to print the configuration page of the NC-2200w. If it is printed, the USB cable connection between the NC-2200w and the Printer/MFC/DCP is OK.

  2. Check the NC-2200w:

     

    Check the LEDs. When the LEDs are lit as follows, the NC-2200w is working OK.

    • 'Link' LED is on (green).
    • 'Infra' LED is on when in the NC-2200w is in Infrastructure mode. (Off when in Ad-hoc mode.)

    If the LEDs are not lit correctly, remove the AC adopter power cable from the NC-2200w and try again.

  3. Check the computer is in Ad-hoc mode.

    Make sure your computer has been configured for Ad-hoc mode.

    The "Wireless Setup Wizard" can only configure the NC-2200 when in Ad-hoc mode.

    To see the quick setup guide, click here (PDF file)

  4. Other Possibilities:


    Make sure that you are using the latest firmware version and software for your Brother wireless product, Access Point and wireless LAN card.

Related Models

NC-2200w

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.