FAQs & Troubleshooting

Close

HL-4000CN

FAQs & Troubleshooting

FAQs & Troubleshooting

HL-4000CN

Not your product?

Date: 01/27/2014 ID: faq00000068_000

How do I install additional memory?

Follow the procedure below to install additional memory.

 

  1. Turn the printer off, and then unplug the power cord from the AC power outlet/socket.

    Before installing the optional accessories, turn the printer off and remove the power plug from the outlet/socket. Installing optional accessories without turning the printer off could result in an electric shock.

  2. Loosen the two screws on the interface board located at the back of the printer.

  3. Hold the two handles on the interface board and slowly pull the interface board towards you, then lay it on a desk or table.

     

  4. Hold the expansion memory module by the edges and align the notches in the module with the protrusions in the slot.

     

  5. Insert the memory module diagonally (1), then tilt it toward the interface board until it clicks into place (2).

    To remove the memory module, open the retaining clips on both sides of the module by pushing them outward, grasp both edges of the module and pull it out straight.

 

Related Models

HL-4000CN, HL-4200CN

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.