FAQs & Troubleshooting



FAQs & Troubleshooting

FAQs & Troubleshooting


Not your product?

Date: 02/14/2013 ID: faq00000316_015

Replace Belt

Follow the steps below to replace the belt unit.

For the order number (Order No.) of the belt unit, click here to see the Consumables & Options page.

  1. Make sure that the machine is turned on.

  2. Open the top cover until it locks in the open position.

    Open top cover

  3. Take out all of the toner cartridge and drum unit assemblies.

    Take out toner and drum

  4. Hold the green handle of the belt unit and lift the belt unit up, and then pull it out.

    Take out belt unit

  5. Unpack the new belt unit and install the new belt unit in the machine.

    Put in belt unit

  6. Slide each toner cartridge and drum unit assembly into the machine. Make sure that you match the toner cartridge color to the same color label on the machine. Repeat this step for each of the toner cartridge and drum unit assemblies.

    Put in toner and drum

    Toner color match

  7. Close the top cover of the machine.

When you replace the belt unit with a new one, you must reset the belt unit counter by completing the following steps:

  1. Press Cancel(Cancel) to interrupt the error.

  2. Press Settings(Settings).

  3. Press All Settings.

  4. Press the Up or Down arrow key to display Machine Info..

  5. Press Machine Info..

  6. Press Parts Life.

  7. Touch the dial pad area to light up the LEDs.

  8. Press # until the machine's display message changes.

  9. Press Belt Unit.

  10. Press Yes.

  11. Press Home(Home).

Related Models

HL-3180CDW, MFC-9130CW, MFC-9330CDW, MFC-9340CDW

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.