FAQs & Troubleshooting

Close

PS5234

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 04/20/2011 ID: faqh00000590_000

How to set the thread change assembly (Two-thread sewing)

Be sure to set the thread change assembly to the machine after completing the needle threading using the needle threader.
(You cannot use the needle threader with the thread change assembly set to the machine.)


  1. Turn off the machine for safety.

  2. Turn the hand wheel so that the mark on the hand wheel is aligned to the  TC mark  mark on the machine.

    Turn the hand wheel so that the mark on the hand wheel is aligned to the [TC] mark on the machine.


  3. Hold the thread change assembly ( 1 ) with your fingertips tightly so that the gap is closed as shown below.

    Hold the thread change assembly with your fingertips tightly so that the gap is closed.


  4. While holding the thread change assembly ( (1) ), push the hole of the thread change assembly onto the upper end of the OL shaft ( (2) ) so that the OL shaft passes through the hole.

    While holding the thread change assembly push the hole of the thread change assembly onto the upper end of the OL shaft so that the OL shaft passes through the hole.


  5. Push the thread change assembly ((1)) fully downward until the tip ((3)) of the thread change assembly is put in the eye of the upper looper ((4)).

    Push the thread change assembly fully downward until the tip of the thread change assembly is put in the eye of the upper looper.


    (A)  Make sure that the tip is in the eye of the upper looper.


  6. Setting of the looper has finished.

 

Related Models

3234DT, 4234DT, 5234PRW, PS5234, PS5234

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.