PE550D
 |
FAQs & Troubleshooting |
PE550D
Date: 02/22/2024 ID: faqh00101093_003
Fabric puckers
-
There is a mistake in the upper or bobbin threading.
Check the steps for threading the machine and rethread it correctly.
Refer to How do I set the bobbin ? , How do I thread my machine ?
-
Spool cap is set incorrectly.
Check the method for attaching the spool cap, then reattach the spool cap.
Refer to How do I thread my machine ?
-
Using improper needle, thread or the fabric prepared insufficiently for embroidering.
Use a ball point needle 75/11 for embroidery.
Use embroidery thread and embroidery bobbin thread.
Attach a stabilizer material for embroidery to the fabric.
-
Needle is turned, bent or the point is dull.
Replace the needle.
Refer to How do I change the needle ?
-
Thread tension is set incorrectly.
Adjust the thread tension.
Embroidery : Refer to How do I adjust thread tension for embroidering ?
-
Fabric and stabilizer are not taut in the embroidery frame.
Set the fabric into the frame correctly.
Refer to How do I hoop the fabric in the embroidery frame ?
-
Incorrect or insufficient stabilizer is being used.
Attach the stabilizer correctly.
Refer to How do I hoop the fabric in the embroidery frame ?
Related FAQs
Innov-is BP1400E, Innov-is NQ1400E, Innov-is NQ1600E , Innov-is NQ1700E, Innov-is NS1150E, Innov-is NS1250E, PE535, PE545, PE550D, PE570, PE800, PE900
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.