EV1-LE
 |
FAQs & Troubleshooting |
EV1-LE
Date: 09/21/2018 ID: faqh00101100_000
Bobbin thread does not wind neatly on the bobbin.
-
The thread is not passed through the bobbin winding thread guide correctly.
Correctly pass the thread through the bobbin winding thread guide.
Refer to How do I wind the bobbin?
-
Bobbin spins slowly.
Press
in the bobbin winding window to increase the bobbin winding speed.
Refer to How do I wind the bobbin?
-
The thread that was pulled out was not wound onto the bobbin correctly.
Wind the thread that was pulled off around the bobbin 5 or 6 times clockwise.
Refer to How do I wind the bobbin?
-
The empty bobbin was not set on the pin properly.
Set the empty bobbin on the pin and slowly turn the bobbin until you hear it click in place.
Refer to How do I wind the bobbin?
Related FAQs
EV1, EV1-LE, Innov-is XE1, Innov-is XE2, Innov-is XJ1, Innov-is XJ2, Innov-is XP1, Innov-is XP2, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.
Please do not enter contact information or any other personal information here.
(We will not respond to any Feedback you send us.)