CM350e
 |
FAQs & Troubleshooting |
CM350e
Date: 08/08/2016 ID: faqh00100481_000
How can I properly emboss without the material tearing?
If the material tore, check the following, and then try again.
| Possible Causes | Solutions |
|
The embossing pressure is too strong. |
If the embossing pressure is too strong, the tool may press down on the material and tear it. Decrease the embossing pressure. |
| Thin paper is being used as the material to be embossed. | Embossing is created by pressing the tool against the material. Thin paper may tear. Use thick paper. |
| The embossing speed is fast. | If the embossing speed is too fast, paper may tear. Decrease the speed, and then try again. |
Adjust the embossing pressure and inward offset in the settings screen for “Premium functions” or embossing screen.
 |
or |  |
CM100DM, CM250, CM350, CM350e, CM350H, CM350R, CM550DX/ CM550, CM650W, CM650WX
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.
Please do not enter contact information or any other personal information here.
(We will not respond to any Feedback you send us.)