TD-4420TN
FAQs & Troubleshooting |
TD-4420TN
Date: 02/20/2020 ID: faqp00100468_000
How to set the Gap/Black Mark Sensor as Media Sensor and calibrate the Gap/Black Mark Sensor by directly operating the printer
Follow the instructions below:
- Turn off the printer.
- Press and hold the Feed/Pause Button and then turn on the printer.
-
For the Black Mark Sensor
Release the button when the LED is lit in green/amber (blinks 5 times alternately) after the green LED flashes five times.
The LED color will change in the following order:
Amber > Red (5 times) > Amber (5 times) > Green (5 times) > Green/Amber (blinks 5 times alternately) (Release the button here) > Red/Amber (blinks 5 times alternately) > Green (lit)
For the Gap Sensor
Release the button when the LED is lit in red/amber (blinks 5 times alternately) after the green/amber LED flashes five times.
The LED color will change in the following order:
Amber > Red (5 times) > Amber (5 times) > Green (5 times) > Green/Amber (blinks 5 times alternately) > Red/Amber (blinks 5 times alternately) (Release the button here) > Green (lit)You can also calibrate by using the BPM (Brother Printer Management Tool).
TD-4420TN, TD-4520TN
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.