RJ-3150
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/rj3150eus.jpg)
RJ-3150
Date: 03/04/2024 ID: faqp00100409_003
Adding a custom media size for continuous roll (Linux®)
To add a custom media size for continuous roll, do the following:
-
Run the command to add a custom media size.
-
Add a new Label Format with the "New Label Format" name and set the 30mm width and length and the 3mm label gap:
"brpapertoollpr_td4550dnwb -P TD4550DNWB -n Papar_Name -w 30 -h 30 -g 3.0 -b 3 -t 3 -r 1.5 -l 1.5 -e 11 -S [0/1/2] [-m 0.0 -o 0.0]" [Enter]
(Type the whole command as a single line before you press enter):
In the case of S=0,1 then program not need (-m 0.0 -o 0.0).
-P Printer Name, e.g. td4550dnwb
-n New Label Name
-w label width
-h label length
-g label spacing
-b bottom margin
-t top margin
-r right margin
-l left margin
-e energyRank[optional]
-S 0/1/2(0:Continuous Length Roll/1:Die-Cut Label/2:Media With Marks)For TD-4420DN(FC)/4550DNWB(FC):
Set 0 (Continuous Length Roll).
-o mark offset
-
Remove the Label Format with the "New Label Format" name:
"brpapertoollpr_td4550dnwb -P TD-4550DNWB -d Paper_Name" [Enter]Enter the Width and Height/Length in mm.
Superuser authorization is required.
-
Add a new Label Format with the "New Label Format" name and set the 30mm width and length and the 3mm label gap:
-
Select the new media size from "Set Printer Options" in "http://localhost:631/printers".
-
Try a test print from "Print Test Page".
RJ-2030, RJ-2050, RJ-2140, RJ-2150, RJ-3050, RJ-3050Ai, RJ-3150, RJ-3150Ai, RJ-3230B, RJ-3250WB, RJ-4230B, RJ-4250WB, TD-4410D, TD-4420DN/4420DN(FC), TD-4520DN, TD-4550DNWB / 4550DNWB(FC)
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.