Before using the rechargeable Li-ion battery (PA-BT-006), use one of the following methods to charge it.

• Recharging the Battery Using the AC Adapter (Optional: PA-AD-600A / PA-AD-600)
• Recharging the Battery Using the Car Adapter (Optional: (PA-CD-600CG)
• Recharging the Battery Using the Battery Charger (Optional: PA-BC-003)
• Recharging the Battery Using the Active Docking Station / Charging Cradle (Optional: PA-CR-002) 

The indicator lights as follows to indicate the status of battery charge.

LED indicator	Status
	Battery is charging.
(when power is turned off) (when power is turned on)	Battery is fully charged.   Disconnect the AC adapter or car adapter from the battery’s DC connector.

Recharging the Battery Using the Battery Charger (Optional: PA-BC-003)

1 Charge indicator 2 Battery charging terminals 3 Battery compartment 4 Locking expansion slot 5 DC connector OUT 6 DC connector IN 7 Locking expansion hook 8 DC cord

1. Connect the AC adapter to the charger’s DC connector IN, and then connect the AC power cord to the AC adapter.
   

   Insert the AC adapter through the opening in the battery charger as shown in the illustration.
   Install the AC adapter so the battery charger does not press on it.

2. Connect the AC power cord to a nearby AC power outlet.
3. Align the charging terminals of the charger and the battery, and then insert the battery.
   The indicator lights in orange when the battery is charging.
4. The charge indicator will turn off when charging is complete.
   You can then remove the battery.
   

[  Back To Top ]

Recharging the Battery Using the Active Docking Station / Charging Cradle (Optional: PA-CR-002)

1 Docking station terminals / Charging cradle terminals 2 Eject button 3 DC connector IN 4 USB port (Printing is possible by connecting the docking station /    charging cradle to a mobile device or a Windows computer via a USB cable.) 5 Docking station terminal attachment / Charging cradle terminals attachment 6 Screws (2 each)

1. Connect the AC adapter to the docking station / charging cradle’s DC connector IN, and then connect the AC power cord to the AC adapter.
   
2. Connect the AC power cord to a nearby AC power outlet.
3. Remove the docking station / charging cradle terminal cover, and use the included screws you removed to install the docking station / charging cradle terminal attachment.
   
   

   Install the docking station / charging cradle terminal attachment. Make sure the notched corner is aligned correctly.

4. Align the docking station terminals / charging cradle terminals of the docking station / charging cradle and the printer, and then press the printer down and onto the docking station / charging cradle until the latches lock it firmly in place.
   The printer’s battery indicator lights in orange when charging.
   
    
5. The printer’s battery indicator will turn off when charging is complete.

[  Back To Top ]

Printer Removal
Push the eject button on the back of the docking station / charging cradle and lift the printer and remove it from the docking station / charging cradle.

1 Eject button

Lock the Eject Button
The eject button can be locked by inserting a cotter pin (or similar) through the hole as illustrated below.
It is recommended to use a Low Carbon Steel Extended Prong Retaining Cotter Pin: Length: 1.97 in. (50 mm), Pin Diameter: 0.08 in. (2 mm).

1 Diameter: 0.09 in. (2.3 mm)
2 Length: 1.62 in. (41.2 mm)

[  Back To Top ]