CP2160P
 |
FAQs & Troubleshooting |
CP2160P
Date: 03/12/2024 ID: faqh00101091_004
Stitches are skipped
-
Machine is not threaded correctly.
(used the wrong spool cap, spool cap is loose, the thread did not catch the needle bar threader, etc.)
Check the steps for threading the machine and rethread it correctly.
Refer to How do I thread my machine?
-
Using improper needle or thread for the selected fabric.
Check the Fabric/Thread/Needle Combinations chart.
Refer to Combination of fabric, thread and needle.
-
Needle is turned, bent or the point is dull.
Replace the needle.
Refer to How do I change the needle ?
-
Needle is installed incorrectly.
Reinstall the needle correctly.
Refer to How do I change the needle ?
-
Needle is defective.
Replace the needle.
Refer to How do I change the needle ?
-
Dust or lint has collected under the needle plate.
Remove the dust or lint with the brush.
Refer to How do I clean the race?
-
Thin or stretch fabrics are being sewn.
Sew with one sheet of thin paper under the fabric.
Refer to Tips for sewing thin fabrics , For better results when sewing stretch fabrics.
Related FAQs
CE1150, CE1155, CP100X, CP2160F, CP2160L, CP2160M, CP2160P, CP2160R, CP2160W, CP60X, CP80X, CS5055, CS7000X
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.