Innov-is XJ2
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_inovxj2eus.jpg)
Innov-is XJ2
Date: 09/26/2018 ID: faqh00101083_000
Stitch pattern does not turn out
-
Wrong presser foot was used.
Attach the correct presser foot.
-
Did not use a stabilizer material on thin fabrics or stretch fabrics.
Attach a stabilizer material.
Refer to Tips for sewing thin fabrics , For better results when sewing stretch fabrics.
-
Thread tension is set incorrectly.
Adjust the thread tension.
Refer to How to adjust the thread tension , Incorrect thread tension.
-
Fabric was pulled, pushed or fed at an angle while it was being sewn.
Sew while guiding the fabric with your hands so that the fabric is fed in a straight line.
-
The thread is tangled, for example, in the bobbin case.
Remove the tangle thread. If the thread is tangled in the bobbin case, clean the race.
Refer to How do I clean the race?
Related FAQs
Innov-is XJ1, Innov-is XJ2, Innov-is XP1, Innov-is XP2, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.