CM650WX
FAQs & Troubleshooting |
CM650WX
Date: 11/28/2013 ID: faqh00000701_000
The machine stopped while an operation is being performed.
Possible Causes (or Results)
For safety, the machine stops operating if the panel is touched while cutting or drawing.
Solutions
Follow the instructions in the message that appears in the screen. Touch the “OK” key to move the carriage to its initial position. Load the mat and perform the operation again.
CM100DM, CM250, CM350, CM350e, CM350H, CM350R, CM550DX/ CM550, CM650W, CM650WX
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.