SDX330D
 |
FAQs & Troubleshooting |
SDX330D
Date: 10/03/2018 ID: faqh00000691_002
The mat is fed in at an angle.
Possible Causes (or Results)
| Case1 : | The mat was inserted into the feed slot at an angle. |
| Case2 : | The corners of the mat are deformed (bent). |
| Case3 : | The rear tray is not pulled out. |
| Case4 : | The feed roller is not positioned correctly. |
| Case5 : | The shaft is released. |
Solutions
----- Case1 -----
Press the 
(Feed) button to feed out the mat.
Re-insert the mat straight in.
 |
 |
 |
----- Case2 -----
Replace the mat with a new one.
----- Case3 -----
Pull out the rear tray.
----- Case4 -----
Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller
----- Case5 -----
Lock the shaft.
SDX125, SDX125e, SDX125e Titanium, SDX125i, SDX125TS, SDX135PRO, SDX225, SDX225F, SDX230D, SDX230Di, SDX230DX, SDX325, SDX330D, SDX85, SDX85C, SDX85M, SDX85S
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.