NX-200
 |
FAQs & Troubleshooting |
NX-200
Date: 01/24/2014 ID: faqh00000465_000
How do I manually thread the needle?
When using special thread, thread with a thickness of 130/20 or thicker, the wing needle or the twin needle which cannot be used with the needle threader, thread the needle as described below.
-
Thread the machine to the needle bar thread guide.
-
Lower the presser foot lever.
Presser foot lever -
Pass the thread through the eye of the needle from front to back.
- Raise the presser foot lever, pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.
Related FAQs
BM-2700, BM-3600, HE-240, Innov-is 1000, Innov-is 1200, Innov-is 1250D, Innov-is 1500D/1500, Innov-is 2500D, Innov-is 2800D, Innov-is 40, Innov-is 40e, Innov-is 80, Innov-is 85e, Innov-is 900D, Innov-is 950D, Innov-is 990D, LB6770/6770PRW, LB-6800, LS-590, NX-200, NX-250, NX-400Q/400, NX-450/450Q, NX570Q, NX-600, NX-650Q, PC-210/210PRW, PC-420/420PRW, PS-21, QC-1000, SB3129, SB4138, SB7500, SB8000, SE1800, SE-350, SE-400, SE425, ST150HDH, XL-2600/2600i/2610, XL-3500/ t/ i/3510/3520, XL-3750, XL-5130/5232/5340, XL-5500, XL-5600, XL-5700
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.