Innov-is NS80e
FAQs & Troubleshooting |
Innov-is NS80e
Date: 11/02/2020 ID: faqh00000061_001
"E3" message appears on the LCD.
Cause
This message is displayed when an erroneous operation is performed as follows.
- The Start/Stop button is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
- The Reverse/Reinforcement stitch button is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
- The foot controller is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
Solution
Lower the buttonhole lever before continuing the operation.
CP100X, CS7000X, Innov-is NS80e, Innov-is NS80PRW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.