Innov-is NS80e
FAQs & Troubleshooting |
Innov-is NS80e
Date: 11/02/2020 ID: faqh00000057_001
"E1" message appears on the LCD.
Cause
This message is displayed when an erroneous operation is performed as follows.
- The Start/Stop button is pressed while the presser foot is raised.
- The Reverse/Reinforcement stitch button is pressed while the presser foot is raised.
- The foot controller is pressed while the presser foot is raised.
Solution
Lower the presser foot lever before continuing the operation.
CP100X, CS7000X, Innov-is NS80e, Innov-is NS80PRW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.