Adding a custom media size for continuous roll (Linux®)
To add a custom media size for continuous roll, do the following:
Run the command to add a custom media size.
Add a new Label Format with the "New Label Format" name and set the 30mm width and length and the 3mm label gap:
"brpapertoollpr_td4550dnwb -P TD4550DNWB -n Papar_Name -w 30 -h 30 -g 3.0 -b 3 -t 3 -r 1.5 -l 1.5 -e 11 -S [0/1/2] [-m 0.0 -o 0.0]" [Enter]
(Type the whole command as a single line before you press enter):
In the case of S=0,1 then program not need (-m 0.0 -o 0.0).
-P Printer Name, e.g. td4550dnwb
-n New Label Name
-w label width
-h label length
-g label spacing
-b bottom margin
-t top margin
-r right margin
-l left margin
-S 0/1/2(0:Continuous Length Roll/1:Die-Cut Label/2:Media With Marks)
-o mark offset
Remove the Label Format with the "New Label Format" name:
"brpapertoollpr_td4550dnwb -P TD-4550DNWB -d Paper_Name" [Enter]
Enter the Width and Height/Length in mm.
Superuser authorization is required.
- Add a new Label Format with the "New Label Format" name and set the 30mm width and length and the 3mm label gap:
Select the new media size from "Set Printer Options" in "http://localhost:631/printers".
Try a test print from "Print Test Page".
TD-4410D, TD-4420DN, TD-4520DN
If you need further assistance, please contact Brother customer service:
Please note this form is used for feedback only.