FAQs & Troubleshooting

Close

HL-6050DN

FAQs & Troubleshooting

FAQs & Troubleshooting

HL-6050DN

Not your product?

Date: 27/01/2014 ID: faq00000068_002

How do I install additional memory?

Follow the procedure below to install additional memory.

 

  1. Turn off the printer power switch, and then unplug the printer. Disconnect the interface cable from the printer.

    Make sure you turn the power to the printer OFF before you install or remove the DIMM.

  2. Slide and remove the side cover.

  3. Open the interface access cover.

  4. Unpack the DIMM and hold it by its edges.

  5. Hold the DIMM on the side edges. Line up the notches on the DIMM with the DIMM slot. (Check that the locks on each side of the DIMM slot are open or  facing outwards.)

  6. Press the DIMM straight into the slot (press firmly). Make sure the locks on each side of the DIMM click into place. (To remove a DIMM, you must release the locks.)

  7. Close the interface access cover.

  8. Put the side cover back on.

  9. Reconnect the interface cable to your printer. Plug the printer back in, and then turn on the printer power switch.

 

Related Models

HL-6050D, HL-6050DN

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.