FAQs & Troubleshooting


Innov-is 50

FAQs & Troubleshooting

FAQs & Troubleshooting

Innov-is 50

Not your product?

Date: 07/08/2014 ID: faqh00100040_000

How do I remove or attach the presser foot holder?


Remove the presser foot holder when cleaning the sewing machine or when installing a presser foot that does not use the presser foot holder, such as the quilting foot. Use the screwdriver to remove the presser foot holder.

Before replacing the presser foot and presser foot holder, be sure to turn off the sewing machine, otherwise injuries may occur if  (start/stop button) is accidentally pressed and the machine starts sewing.

 Removing the presser foot holder

  1. Remove the presser foot.
    For details, refer to Replacing the presser foot.
  2. Use the screwdriver to loosen the presser foot holder screw.
    (1) Screwdriver

    (2) Presser foot holder

    (3) Presser foot holder screw

Attaching the presser foot holder

  1. Align the presser foot holder with the lower left side of the presser bar. 
    (1) Presser bar

    (2) Presser foot holder

  2. Hold the presser foot holder in place with your right hand, and then tighten the screw using the screwdriver in your left hand.
    (1)  Screwdriver

    If the presser foot holder is not correctly installed, the thread tension will be incorrect.


Related FAQs

Related Models

Innov-is 50, Innov-is 55P

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.