FAQs & Troubleshooting

Close

PR1055X

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 29/07/2016 ID: faqh00000599_004

Maintenance (Oiling the machine)

In order to extend the life of the embroidery machine’s parts and keep the machine operating correctly, be sure to oil the machine before the first time that it is used. If too little oil was applied to the race, an error message may appear.
Afterward, put a drop of oil onto the hook once a day before use, and put a drop of oil to the lower needle bar felt washer every 40 to 50 hours of machine use.

 

Oiling the race

 

  1. Touch

     
  2. Touch



    Following message appears.


  3. Open the hook cover, and remove the bobbin case.

    Remove the bobbin case

  4. Touch "OK".
    The race moves to the correct position for oiling.

  5. Put a drop of oil onto the hook.
     
    image
    Front angle view   Side view


    (1) Punch a small hole in oil bottle.
    (2) Apply oil here.
     

     

  6. Touch "OK" appeared in the following screen.
    The race backs to its original position.


  7. After oiling, insert the bobbin case into the hook, and then close the hook cover.
     

    Close the hook cover

    Be sure to close the hook cover before using the embroidery machine. The fabric is caught and causes the trouble if the hook cover is opened.

 

Oiling the needle bars

From embroidering screen, select one needle bar at a time. Turn the handwheel counterclockwise bringing the needle bar to its lowest position. Put one drop of oil, as high as possible on the needle bar above the felt washer.
 

Put one drop of oil on the lower needle bar felt washer
(1) Apply oil here.

 

  • Too much oil may drip onto sewing project.
     
  • Put a drop of oil onto the hook once a day before use.
     
  • Apply one drop of oil on the lower needle bar above the felt washer every 40 – 50 hours of sewing time.
     
  • Apply only sewing machine oil. Use of any other type of oil may result in damage to the embroidery machine.
     
  • Do not apply too much oil. Fabric or thread may get contaminated. If too much oil is applied, wipe off any excess with a rag.
     
  • If the thread breaks while sewing or the operating noise of the hook becomes loud, apply oil onto the race hook.

Related FAQs

Related Models

PR1050X, PR1055X

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.