Innov-is 95E
 |
FAQs & Troubleshooting |
Innov-is 95E
Date: 07/04/2009 ID: faqh00000006_000
Place a spool of thread on a spool pin.
<Horizontal spool pin>
If a spool of thread turns too much and thread tension becomes improper, place a felt under the spool of thread.
- Firmly hold the thread with a spool cap so that the thread does not turn too much.
Spool capMake sure you use the correct size spool cap for the thread. If the spool cap is smaller the thread, tension may be incorrect.
- If you dont have a spool cap larger than the size of the thread, there is a slit in the thread spool.
Slit(Notch)Install the spoll so that the slit faces the base of the spool pin.
- It is important that the thread is pulled out from the spool smoothly. Make sure there is space around the spool cap and the tip of the spool pin for thread to pass through.
If a spool of thread turns too much and thread tension becomes improper, place a felt under the spool of thread.
 |
 Felt Spool pin |
BC-2100/BC-2100PRW, BM-3500/2600, DS-140, FS101, FS50, Innov-is 1500D/1500, Innov-is 50, Innov-is 55P, Innov-is 750E, Innov-is 950, Innov-is 95E, Innov-is 980D, Innov-is 980K, LS-2125/2160, NX-400Q/400, NX-600, QC-1000
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.