FAQs & Troubleshooting

Close

PX-100/200/300

FAQs & Troubleshooting

FAQs & Troubleshooting

PX-100/200/300

Not your product?

Date: 20/11/2012 ID: faqh00000027_000

Why does my thread keep jamming?

The thread could be jamming due to several reasons.
  • The upper thread could be tangled.
    Remove the thread completely from the machine. 
    The correct size spool cap should be used for the size of the thread spool.
    Re-thread the machine according to the directions in the manual.

Please refer to "Upper threading" of "Preparation" category.

One Point Advice   Place a spool of thread on a spool pin

  • Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race. 
    Remove any loose threads or lint in the shuttle race.

Please refer to "Installing a bobbin" of "Preparation" category.

One Point Advice   When thread got tangled

  • The tension could be too tight or too loose.
    Set the tension to the basic thread tension setting or adjust the tension manually.

  • The combination of the needle size, thread size and fabric is incorrect.
    Be sure to use the correct size needle and thread for the type of fabric that you are sewing.
    (Example: Denim-size 16 needle and 40-50 heavy-duty thread )

One Point Advice   Combination of fabric, thread and needle

Related FAQs

Related Models

BM-3500/2600, FS101, Innov-is 50, Innov-is 55P, Innov-is 980D, LS-1217, LS-2125/2160, PE-300S, PX-100/200/300, XL-5500

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.