Innov-is A150
FAQs & Troubleshooting |
Innov-is A150
Date: 17/02/2022 ID: faqh00000135_001
"Change the speed controller mode to "OFF"." message appears on the LCD.
Cause
This message is displayed when the sewing speed controller is set to control the zigzag stitch width, and the Start/Stop button is pressed.
Solution
Use the foot controller to operate the machine.
If you want to operate the machine with Start/Stop button, set Width control settings to OFF in the settings screen as follows.
-
Press (Settings key) to display the settings screen.
-
Display the second page of the settings screen by pressing .
The item (Width control) is selected.
-
Change the value of width control from [ON] to [OFF] by pressing or .
(1) : Press this key to move to previous page.
(2) : Press this key to move to next page.
(3) : Press this key to select the next item.
(4) : Press this key to select the previous item.
(5) : Press this key to change the value of the selected item.
(6) : Press this key to change the value of the selected item.
- Press (Back key) or (OK key) to close the settings screen.
Innov-is A150
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.