DCP-T310
FAQs & Troubleshooting |
DCP-T310
Date: 26/04/2018 ID: faq00003017_507
Copy an ID Card
Use the [2in1(ID)] feature to copy both sides of an identification card onto one page, keeping the original card size.
Make sure the paper size is set to A4 or Letter.
- You may copy an identification card to the extent permitted under applicable laws. For more detailed information, see the Product Safety Guide.
DCP-T310/DCP-T510W/DCP-T710W/MFC-T810W
- Place your identification card face down near the upper-left corner of the scanner glass.
- 3 mm or greater (top, left)
- 207 mm
- 145 mm
- Scannable area
- (MFC-T810W) Press (COPY).
- Enter the number of copies in one of the following ways:
- (DCP-T510W/DCP-T710W) Press or on the control panel.
- (MFC-T810W) Enter the number of copies using the dial pad.
- (DCP-T310) Press Number of Copies repeatedly.
- Press Options or Copy / Scan Options and or to select [Layout(2in1 ID)]. Press OK.
- Press or to select [2in1(ID)]. Press OK.
- Press Mono Start or Colour Start.The machine starts scanning one side of the identification card.
- After the machine has scanned the first side, turn over the identification card and press Mono Start or Colour Start to scan the other side.
MFC-T910DW
- Place your identification card face down near the upper-left corner of the scanner glass.
- 3 mm or greater (top, left)
- 207 mm
- 145 mm
- Scannable area
- Press (COPY).
- Enter the number of copies using the dial pad.
- Press or to select the following:
- Select [Page Layout]. Press OK.
- Select [2in1(ID)]. Press OK.
- Press Mono Start or Colour Start.The machine starts scanning one side of the identification card.
- After the machine has scanned the first side, turn over the identification card and press to scan the other side.
DCP-T310, DCP-T510W, DCP-T710W, MFC-T810W, MFC-T910DW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.