1. Press the Ink key located to the left side of the number pad on the Control Panel.
2. Press the up or down navigation key to select REPLACE INK. Then press Menu/Set. The display will then prompt you PLS OPEN COVER.
3. Open the Scanner Cover by pulling up on the edge of the cover just above the LCD.
   

4. Open the appropriate color ink cartridge cover by pressing "Push" and lift the ink cartridge out of the carriage.
   

5. Open the new ink cartridge bag for the color shown on the LCD and take out the ink cartridge.
6. Hold the new ink cartridge as shown in the illustration and peel the sealing tape from the side of the ink cartridge. Carefully peel the tape in the direction away from you.
   

7. Each color has its own correct position. Insert each new ink cartridge into the carriage.
   

8. After installing the ink cartridge, close the ink cover by pushing the END of the cover back down.
   

9. Close the Scanner Cover.
10. The LCD will then display:
    Have you removed Blck? 1.Yes 2.No.
    If you replaced the ink cartridge, press 1 YES .
    -OR-
    If you did not replace the ink cartridge, press 2 NO.
    
    BE SURE to select 1 Yes, if you replaced the ink.
    If 1 YES is not selected for the replaced cartridges, INK EMPTY will appear again. If 1 Yes is selected, the LCD will then display "Change to new (color)? 1 Yes 2 No". Again, BE SURE to select 1 YES.

The LCD will display "Have you removed..." for ALL 4 colors in sequence (not just the ones replaced). BE SURE to select 1 YES for each ink cartridge that was replaced.

The MFC will enter a cleaning cycle for approximately 3 minutes for each replaced cartridge. The LCD alternately shows CLEANING and PLEASE WAIT. When the MFC completes the cleaning cycle, the LCD returns to Standby mode (date and time).