HL-3450CN
![]() |
FAQs & Troubleshooting |

HL-3450CN
Date: 27/01/2014 ID: faq00000164_002
"JAM E1/E2" error appears on the LCD. What should I do? (For users who installed the DX-3400 DUPLEX UNIT)
When the following message appears on the LCD with the Duplex Unit installed, follow the steps below to remove the jammed paper:
JAM E1 |
OR
JAM E2 |
-
Open the Duplex Lower Cover.
-
Open the Inside Unit of the Duplex Unit.
-
Open the Rear Access Cover of the printer.
-
Open the Duplex Cover Top Assembly.
-
Open the Top Cover of the printer, and then set the Pressure Release Levers of the Fusing Unit to the OPEN position.
-
With all the covers and units open, remove the jammed paper. Access and remove the jammed paper from the Rear Access Cover.
-
Set the Pressure Release Levers of the Fusing Unit to the SET position, and then close the Top Cover.
-
Close the Duplex Cover Top Assembly.
-
Close the Rear Access Cover of the printer.
- Close the Inside Unit and the Duplex Lower Cover of the Duplex Unit.
Content Feedback
Please note this form is used for feedback only.