Innov-is XP1

FAQs & Troubleshooting

Innov-is XP1

Date: 15/10/2019 ID: faqh00101089_000

Needle is turned, bent or the point is dull.

Replace the needle.
Refer to How do I change the needle?
Dust or lint is caught in the feed dogs.

Remove the dust or lint.
Refer to How do I clean the race?
Pieces of thread are caught in the race.

Clean the race.
Refer to How do I clean the race?
Upper threading is incorrect.

Check the steps for threading the machine and rethread the machine.
Refer to How do I thread my machine ?
A bobbin designed specifically for this machine is not used.

Incorrect bobbins will not work properly.
Only use a bobbin designed specifically for this machine.
Refer to How do I set the bobbin ?
There are needle holes or friction scratches in the bobbin case.

Replace the bobbin case, or consult your authorized Brother dealer.

Innov-is XJ1, Innov-is XP1, Innov-is XP2, Innov-is XP3

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Very helpful

Helpful

Not helpful

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.