Innov-is XJ1
 |
FAQs & Troubleshooting |
Innov-is XJ1
Date: 29/07/2019 ID: faqh00101088_001
Fabric does not feed through the machine.
-
Feed dogs are set in the down position.
Press
, and then turn the handwheel to raise the feed dogs.
-
Stitches are too close together.
Lengthen the stitch length setting.
Refer to How do I adjust a stitch width or length?
-
Wrong presser foot.
Use the correct presser foot.
-
Needle is turned, bent or the point is dull.
Replace the needle.
Refer to How do I change the needle ?
-
Thread is entangled.
Cut the entangled thread and remove it from the race.
-
Zigzag foot J is slanted on a thick seam at the beginning of stitching.
Use the presser foot locking pin (black button on the left side) on zigzag foot J to keep the presser foot level while sewing.
Refer to Tips for sewing thick fabrics.
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.