FS60X
 |
FAQs & Troubleshooting |
FS60X
Date: 19/05/2023 ID: faqh00101524_000
How do I sew hook-and-loop fasteners(hook-and-loop tapes)?
- Use only the adhesive-free hook-and-loop fastener tape which is designed for sewing.
- Adhesive backed hook-and-loop fastener tape is not designed for sewing. Do not use adhesive backed hook-and-loop fastener tape. When glue adheres to the needle or the bobbin hook race, it may cause malfunction.
- If the hook-and-loop fastener tape is sewn with the thin needle (65/9-75/11), the needle may bend or break.
- Before starting to sew, baste the fabric and hook-and-loop fastener tape together.
Make sure that the needle passes through the hook-and-loop fastener tape by turning the handwheel and lower the needle into the hook-and-loop fastener tape before sewing. And then, sew the edge of the hook-and-loop fastener tape at a slow speed.
If the needle does not pass through the hook-and-loop fastener tape, replace the needle with the needle size for thicker fabrics. For details, refer to "Combination of fabric, thread and needle".
 |
(1) Edge of the hook-and-loop fastener tape |
FS60X, FS80X
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.