CM900
 |
FAQs & Troubleshooting |
CM900
Date: 19/08/2015 ID: faqh00000703_000
There are deep cuts completely through the mat.
Possible Causes (or Results)
Case1 : The blade extension from the blade holder is too much.
Case2 : The cutting pressure (“Cut Pressure”) is incorrect.
Solutions
----- Case1 -----
Remove the holder from the carriage, and then adjust the blade extension.
(1) Turn to the left to decrease the blade extension.
(2) Turn to the right to increase the blade extension.
>> For details, see “Adjusting the Blade Extension”.
----- Case2 -----
Adjust the setting for “Cut Pressure” in the settings screen.
>> For details, see “Adjusting the Blade Extension”.
>> For details, see “Settings for Specific Functions”.
Related FAQs
CM110, CM350, CM550DX/ CM550, CM900
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.