FAQs & Troubleshooting

Close

BC-2500

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 03/11/2015 ID: faqh00100040_005

How do I remove or attach the presser foot holder?

Remove the presser foot holder when cleaning the sewing machine or when installing a presser foot that does not use the presser foot holder, such as the quilting foot. Use the screwdriver to remove the presser foot holder.

 

 

  1. Remove the presser foot.
    For details, refer to How do I remove or attach the presser foot?

     

  2. Use the screwdriver to loosen the presser foot holder screw.
    Turn the screw toward the back of the machine (counterclockwise).
    image (1) Screwdriver

    (2) Presser foot holder

    (3) Presser foot holder screw

     

  3. Remove the presser foot holder.

     

  4. Align the presser foot holder with the lower-left side of the presser bar.
    image (1) Presser foot holder

    (2) Presser bar

     

  5. Hold the presser foot holder in place with your right hand,  and then tighten the screw using the screwdriver in your left hand.
    Turn the screw toward you (clockwise).
    image (1) Screwdriver

    (2) Presser foot holder

    (3) Presser foot holder screw

     

    Be sure to securely tighten the presser foot holder screw, otherwise the presser foot holder may fall off and the needle may strike it, causing the needle to bend or break.

    If the presser foot holder is not correctly installed, the thread tension will be incorrect.

 

Related FAQs

Related Models

BC-2500, CS-6000/6000b/6000t

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.